| Quantity: | |
|---|---|
Emax
HDG Electric Power Fittings Pole Line Hardware Guy Hook
Product Description:
Engineered to meet CSA C83.100 standards, this hot-dip galvanized guy hook delivers exceptional mechanical performance for utility pole stabilization. Crafted from ductile iron 65-45-12 (ASTM A536), it combines high tensile strength with impact resistance, ensuring reliability in extreme weather conditions and seismic zones.
Certified Load Capacity:
Minimum Ultimate Strength:
P1: 90 kN (20,250 lbs)
P2: 60 kN (13,500 lbs)
Ductility: 12% elongation (exceeds ASTM A536 requirements)
Precision Manufacturing:
Dimensional compliance with dual-unit markings (inches/mm)
Uniform hot-dip galvanizing per SPEC 12505 / CSA G164 (≥85μm coating)
3° draft angles and controlled radii (R≥0.09") for stress distribution
Quality Validation:
Batch-tested to verify:
Salt spray resistance: 1,000+ hours (ASTM B117)
Charpy impact value: 20J @ -40°C
Full traceability with heat number identification
Applications:
Transmission tower guying (IEEE 1508 compliant)
Distribution pole anchoring in coastal/high-wind zones
Temporary emergency repair systems
Why Specify This Guy Hook?
Failure Prevention: Ductile iron design bends without fracturing
Corrosion Resistance: Zinc coating protects in C5 marine environments
Global Compliance: Meets CSA, IEEE, and IEC standards
Email: jane@emaxmetal.com
HDG Electric Power Fittings Pole Line Hardware Guy Hook
Product Description:
Engineered to meet CSA C83.100 standards, this hot-dip galvanized guy hook delivers exceptional mechanical performance for utility pole stabilization. Crafted from ductile iron 65-45-12 (ASTM A536), it combines high tensile strength with impact resistance, ensuring reliability in extreme weather conditions and seismic zones.
Certified Load Capacity:
Minimum Ultimate Strength:
P1: 90 kN (20,250 lbs)
P2: 60 kN (13,500 lbs)
Ductility: 12% elongation (exceeds ASTM A536 requirements)
Precision Manufacturing:
Dimensional compliance with dual-unit markings (inches/mm)
Uniform hot-dip galvanizing per SPEC 12505 / CSA G164 (≥85μm coating)
3° draft angles and controlled radii (R≥0.09") for stress distribution
Quality Validation:
Batch-tested to verify:
Salt spray resistance: 1,000+ hours (ASTM B117)
Charpy impact value: 20J @ -40°C
Full traceability with heat number identification
Applications:
Transmission tower guying (IEEE 1508 compliant)
Distribution pole anchoring in coastal/high-wind zones
Temporary emergency repair systems
Why Specify This Guy Hook?
Failure Prevention: Ductile iron design bends without fracturing
Corrosion Resistance: Zinc coating protects in C5 marine environments
Global Compliance: Meets CSA, IEEE, and IEC standards
Email: jane@emaxmetal.com
